Don't know if the platform is more dangerous in this regard than a striker fired pistol. I'm toying with doing a few of these conversions for others -- either with your. No registered users and 2 guests. I placed a strip of neon in the rail so I can better tell up and down etc. Don't polish the side of the slides very much if at all. If it's out of battery it can't go off.
But - just for argument, many 9x18mm ie: Are you sure it is in. Too heavy in comparison to all the new minis out there now, and a pain to take down for cleaning. Visit ColbyBruce photo album. This is a discussion on AMT backup.
It'll help some if you have three hands. Find all posts by AGE. For a pretty compact piece, it weighed a short ton. I was amazed when I did the field strip the first time to find out that there was not a single machined part in the weapon. The short barreled 10's usually have such a hi slide velocity that they never function properly. If someone were stupid, at least they'd have an excuse for all the dumb things they say.
Equalizer load to start. Anyone know something about it?? After getting no support from High Standard for warranty replacement of the grip screws, I began to look for other alternatives. I would recommend junking all of them. Release the pressure and you're done. As to cleaning, I only did normal 'field' cleanings and never had any performance suggestion that more was required. Other than closer than 15' or so my shots are nothing like those posted by Los.